Kamis, 17 Oktober 2013

Bayou Classic 0-30 PSI Adjustible Regulator/Hose Assembely


Bayou Classic 0-30 PSI adjustible regulator/hose assembly. The M5HPR-30 is a great compliment or addition to Bayou Classic jet cookers and banjo burners.It features a 30 PSI regulator with a 48-inch stainless braided hose.3/8” Flare fitting has an outside diameter of 5/8”.
  • 0-30 psi adjustable regulator
  • 48-inch stainless braided hose
  • 3/8 flare swivel fitting
  • 3/8-Inch Flare fitting has an outside diameter of 5/8-Inch

This All Products give to us some advantages, like this :
1. Works great with a jet burner....but
I bought 2 of these and put them on my Bayou Classic SP2 double jet burners. HUGE improvement over the 20 psi regulators that came on them. (I think SP2 burners now come standrad with this regulator).

I used them for the first time this past weekend on a 1000 pound crawfish boil and they were the workhorses, tremendously out-performed the 5 other single jet burners. Please note: when firing these regulators up, be sure to slowly turn on the propane tank valve first, then slowly turn on the regulator. When you turn it off, you must turn off the propane tank valve first, then turn off the regulator. If you don't do it in this order, it will likely activate the safety gas flow devices in the tank and/or the regulator and you will have a small, useless flame.

EDIT 6/11/2013. I have found that if you run these regulators at the full wide open setting, the safety shut off valve will activate randomly, resulting in a puny, worthless flame. When this happens, you have...

2. Took care of all my gas grill problems
This is a pretty well made regulator, but not nearly as good as what you might buy down at a welding shop for 3 times the price. 0n the other hand, it is far better suited for putting on a home grill than the cheap non-adjustable regulators that typically come with the grill or that you buy as replacements.

I have a 15 year old stainless grill with ceramic parts that last forever, but the the three cast iron burners keep burning/rusting out. Even with brand new burners in it, it would barely heat up the grill, and if you turned on more than one burner, the flames got even lower. Even with new burners, it was pretty much a useless device on the back porch, due to the low flame.

I did all the "reset the safety valve" procedures, but nothing helped. I determined that the regulator was not delivering enough gas, but I did not know what the proper pressure for that particular 3 burner setup was, so I decided to get an adjustable regulator with more than just...

Need more appointment... ?
It's all about flame control
I bought this to use on my propane SMOKER for better/easier flame adjustment. Factory preset regulators are set to 20 pounds of pressure, this let's you operate from "0" to 30 lbs. My smoker valve changes the flame too much with only a slight turn. This allows me to change flame as little or greatly as needed. The trick is to have smoker control set to high, then regulate the flame by this unit.
More information by CLICK HERE.

Tidak ada komentar:

Posting Komentar